Command Start CS-580i FM Installationsanleitung PDF herunterladen (Seite 16)

P. 16 Installation Guide

Supplementary Information

Fifth Relay Output (2

IGN, ACC or CRANK)

Systems of this series are equipped with an

on-board high-current programmable 5

Relay that can be used to power a second

Ignition, Accessory or Crank wire.

The Unit uses 3 sets of pins; each set

corresponds to a specific function of the

output. In order to activate one of the three

possible functions, you must place the

Jumper (supplied) on one of the three sets

of pins and connect the 14 AWG wire to the

second IGN. / ACC. / CRANK wire of the

vehicle.

Caution!

Only one set of pins can be used at one time. Using more than one Jumper may result in

serious damage to the vehicle.

The relay output rating on this unit is 25 A at most. Defective OEM solenoid switches can

sometimes draw up to 50 or 60 A, causing the 30 A Fuse to blow. Always verify your circuit

with an appropriate measuring device.

Ignition-controlled Door Locks

This feature will LOCK all the Doors of the vehicle when the Brake Pedal is pressed while the

Ignition Key is in the

IGNITION ON (RUN) position. The unit will UNLOCK all Doors when the

Ignition Key is turned back to the

OFF position.

If Ignition Lock Only is selected, the system will only

LOCK all Doors when the Brake Pedal

is pressed while the Ignition Key is in the

IGNITION ON (RUN) position.

If option Ignition Unlock Only is selected, the system will

UNLOCK all Doors when the key is

turned to the

OFF position (provided that the Ignition key was in the IGNITION ON (RUN) position

and that the Brake Pedal was pressed at least once).

Ignition Re-lock

This feature is automatically available whenever Ignition Lock is available. When Ignition is

ON (but not under remote start) and a Door is opened and closed, the system will re-lock all

doors next time the Brake Pedal is pressed.

Secure Lock

This feature allows the System to control certain OEM factory Alarm systems without

requiring the use of other wires for disarming the OEM Alarm. (Namely, this feature is

designed for OEM systems which use the factory Lock wire to arm the Alarm and the

Unlock wire to disarm it.)

Standard Secure Lock

If this Option is selected, upon receiving a remote START signal, Secure Lock will UNLOCK the

Doors (disarming the factory Alarm); 1/2 sec. after remote start Secure Lock will re-lock the

Doors. 4 seconds after shutdown, Secure Lock will re-lock all Doors (arming the system

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22

Kommentare zu diesen Handbüchern

Keine Kommentare

Command Start CS-580i FM Installationsanleitung Seite 16

Kommentare zu diesen Handbüchern