Command Start CS-580i FM Installationsanleitung PDF herunterladen (Seite 14)

P. 14 Installation Guide

Automatic Tach Programming

This simple procedure can replace the Multi-speed Tach Programming procedure:

1. Make sure that all the connections are properly made and that the System is

powered up.

2. With the Hood up (ground on the Hood Pin switch line), start the vehicle using the

Key.

3. Allow the vehicle to reach regular Engine idle speed.

The Parking Light output from the System will activate when the vehicle starts

and shut off once a Tach signal is detected.

4. Press the Brake Pedal and keep it down until you hear the Parking Lights Output

flash 5 times and the siren will chirp twice.

5. Shut down the Engine. Tach Programming is now complete.

Table 6: Automatic Tach Programming

Siren or Horn Chirp Timing

Follow these steps to program Siren or Horn Confirmation:

1. Ensure that the Hood is up and that the Ignition is OFF.

• Hold the Hood Pin-switch down for 4 seconds.

• Release the Pin-switch. The Parking Lights will come on.

• While the Parking Lights are on, immediately push and release the

Pin-switch again. The Parking Lights will stay on for up to 20 seconds.

2. Press and hold the Brake Pedal, then simultaneously press the UNLOCK and

START/STOP buttons on the Transmitter – the Siren or Horn will chirp 5 times.

3. Release the Brake Pedal.

4. To change the timing:

a. To increase the Siren or Horn pulse by 3 ms, press the LOCK button.

b. To decrease the pulse by 3 ms, press the UNLOCK button.

c. To increase the pulse by 10 ms, press the START/STOP button.

d. To decrease the pulse by 10 ms, press the TRUNK button.

5. To save the new settings: press LOCK and UNLOCK. If 3 chirps are returned the new

settings have been saved.

Table 7: Adjusting Chirp Duration

Otherwise close the Hood to cancel the changes.

Note

Select Siren or Horn in the Programming Options.

The Siren and the Horn each have their own settings. Changing the settings of one of them will not

affect the settings of the other.

For each timing change, the Siren or Horn will chirp with the new settings, except in

the following cases:

• When the lower limit of 5 ms is reached, there will be a 1/4-sec. chirp.

• When the upper limit of 200 ms is reached, there will be a 3/4-sec. chirp.

A system reset will set the System back to the default values: 30 ms for the Horn and

120 ms for the Siren.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21 22

Keine Kommentare

Command Start CS-580i FM Installationsanleitung Seite 14