User Guide P. 15
Diagnostics – Parking Light Flash Table
Flashes Description
1
• Doors locked, Alarm and Starter Kill armed.
• End of Run Time.
•
TRUNK button pressed
• Start signal received by the System.
• Cold Weather Mode cancelled.
• Cannot start after maximum number of attempts is reached.
2
• Doors unlocked, alarm and starter Kill disarmed.
• Run time cancelled.
• Exit remote valet.
• Exit ignition valet
• Remote start attempt cancelled by remote.
3
• Entering cold weather mode.
• Entering remote valet.
• Entering ignition valet
4
• +12 V where detected on the brake line and cranking was cancelled.
• Entering tach-programming mode
5
• New transmitter programmed.
• Tach programmed.
6
• A remote start was attempted while a tach or a vacuum signal was detected before
cranking.
8 • Unit reset: occurs when the unit is reset to the factory defaults.
10 • The hood switch line went to ground during cranking or run time.
1 – pause – 2 • There was an attempt to start the vehicle while the system was in valet mode.
2 – pause – 2 • There was an attempt to start the vehicle while the system was in home valet mode.
ON solid • Cold weather mode: the Brake Pedal is being held down.
ON 2 sec.
• The Hood is up and the Hood Switch line went to ground. This is step one of the
Programming Centre procedure.
ON 3 sec. • First press of the START/STOP button under Safe Start.
ON 4 sec. • Locking or unlocking a door (with Door pulses configured to 4 sec.)
ON 25 sec.
• The hood pin-switch has been pressed twice: the unit went into step 1 of the
programming centre procedure, and no transmitter activity was detected for 20
seconds.
• Or the unit went into step 1 of the transmitter programming procedure and no activity
was detected for a few seconds. The unit has exited the transmitter programming
procedure.
Irregular
• If the unit gives irregular signals (1 to 10 flashes followed by a pause, followed by
further flashes), the system is playing back start failure codes. This occurs when the
hood pin-switch is pressed three times.
Constant
flashes
up to 30 sec.
• In horn mode: alarm condition generated by an intrusion, by panic mode or when the
system is powered up.
Constant
flashes
up to 60 sec.
• In siren mode: alarm condition generated by an intrusion, by panic mode or when the
system is powered up.
(45 Seiten)
(33 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern