Command Start CS-580i FM Wartungshandbuch

© 2007 Panasonic HA Air-Conditioning (M) Sdn. Bhd.(11969-T). All rights reserved. Unauthorized copyingand distribution is a violation of law.Order No.

102.4. Outdoor Unit: CU-2E15GBE

112.5. Outdoor Unit: CU-3E18EBE

122.6. Outdoor Unit: CU-3E23CBPG CU-4E27CBPG

13

14

15

163Features• Inverter Technology- Wider output power range- Energy saving- Quick Cooling-Quick Heating- More precise temperature control• E-ion Air Pu

17• Multi Split Combination Possibility:- A single outdoor unit enables air conditioning of up to two separate rooms for CU-2E15GBE, CU-2E18CBPG.- A s

184 Location of Controls and Components4.1. Indoor Unit4.2. Outdoor Unit4.3. Remote Control

195 Dimensions5.1. Indoor Unit

29.2. Outdoor Unit ----------------------------------------------- 2610 Printed Circuit Board ------------------------------------------ 2710.1. Indoo

205.2. Outdoor Unit

216 Refrigeration Cycle Diagram If piping length is over common length, additional refrigerant should be added as shown in the table.ModelPiping size

227 Block Diagram

238 Wiring Connection Diagram8.1. Indoor Unit

248.2. Outdoor Unit

259 Electronic Circuit Diagram9.1. Indoor Unit

269.2. Outdoor Unit

2710 Printed Circuit Board10.1. Indoor Unit10.1.1. Main Printed Circuit Board

2810.1.2. Power Printed Circuit Board10.1.3. Indicator Printed Circuit Board10.1.4. Patrol Printed Circuit Board

2910.2. Outdoor Unit

36. This equipment is strongly recommended to install with Earth Leakage Circuit Breaker (ELCB) or Residual Current Device (RCD).Otherwise, it may cau

3011 Installation Instruction11.1. Select The Best LocationINDOOR UNIT• Do not install the unit in excessive oil fume area such askitchen, workshop an

3111.3. Indoor Unit11.3.1. HOW TO FIX INSTALLATION PLATEThe mounting wall is strong and solid enough to prevent it fromthe vibration.The centre of ins

323. For the embedded piping(This can be used for left rear piping and left bottom pipingalso.)

3311.3.4. CONNECT THE CABLE TO THEINDOOR UNIT1. The inside and outside connecting cable can beconnected without removing the front grille.2. Connectin

3411.4. Outdoor Unit11.4.1. INSTALL THE OUTDOOR UNIT• After selecting the best location, start installation accordingto Indoor/Outdoor Unit Installati

3511.4.3. EVACUATION OF THE EQUIPMENTWHEN INSTALLING AN AIR CONDITIONER, BE SURE TO EVACUATE THE AIR INSIDE THE INDOOR UNIT AND PIPES in thefollowing

364. Cable connection to the power supply through knife switch (Disconnecting means).• Connect the approved polychloroprene sheathed power supply cabl

3712 Operation Control12.1. Basic FunctionInverter control, which equipped with a microcomputer in determining the most suitable operating mode as tim

3812.1.5. Automatic Operation• This mode can be set using remote control and the operation is decided by remote control setting temperature, remote co

39[Heating]• According to indoor pipe temperature, automatic heating fan speed is determined as follows.B. Feedback control• Immediately after the fan

42 Specifications2.1. CS-CE7HKEW CU-CE7HKEITEM UNIT INDOOR UNIT OUTDOOR UNITPerformance Test Condition EUROVENTCOOLINGCapacitykW 2.05 (0.70 ~ 2.40)kC

402. Manual vertical airflow direction can be set using remote control; the angles of the vane are as stated above and the positionsof the vane are as

412. When quiet operation is stopped, operation is shifted to normal operation with previous setting.3. When fan speed is changed, quiet operation is

4212.10. Indication PanelNote:• If POWER LED is blinking, the possible operation of the unit are Hot Start, during Deice operation, operation mode jud

43c. Patrol operation disable• To disable the Patrol Operation during unit start (default) with “OFF/ON” button, press “Patrol” button and hold for 5

44e. Indicator• When Patrol operation starts, Patrol Sensor indicator ON.• When e-ion operation starts based on dirtiness level, e-ion indicator ON.g.

45C. Control Contenta. Indoor fan control• During any operation mode combines with e-ion operation, fan speed follows respective operation mode.• Duri

46Error Reset Method• Press “OFF/ON” button to OFF the operation.• Press AUTO OFF/ON button at indoor unit to OFF the operation.• OFF Timer activates.

4713 Protection Control13.1. Protection Control For All Operations13.1.1. Restart Control (Time Delay Safety Control)• The Compressor will not turn on

4813.1.5. Compressor Overheating Prevention Control• Instructed frequency for compressor operation will be regulated by compressor discharge temperatu

4913.1.9. Low Frequency Protection Control 2• When all the below conditions comply, the compressor frequency will change to lower frequency.13.2. Prot

51. Cooling capacities are based on indoor temperature of 27qC D.B. (80.6qF D.B.), 19.0qC W.B. (66.2qF W.B.) and outdoor airtemperature of 35qC D.B. (

5013.2.5. Dew Prevention Control 2• To prevent dew formation at indoor unit discharge area.• This control starts if all conditions continue for 20 min

5114 Servicing Mode14.1. Auto OFF/ON Button1. AUTO OPERATION MODEThe Auto operation will be activated immediately once the Auto OFF/ON button is press

52• During Remote Control Number Switch Mode, press any button at remote control to transmit and store the transmission code tothe EEPROM.14.3. Remote

5315 Troubleshooting Guide15.1. Refrigeration Cycle SystemIn order to diagnose malfunctions, make sure that there are noelectrical problems before ins

5415.1.1. Relationship between the condition of the air conditioner and pressure and electriccurrent• Carry out the measurements of pressure, electric

5515.2. Breakdown Self Diagnosis Function15.2.1. Self Diagnosis Function (Three Digits Alphanumeric Code)• Once abnormality has occurred during operat

5615.3. Error Codes TableNote:“O” - Frequency measured and fan speed fixed.The memory data of error code is erased when the power supply is cut off, o

5716 Disassembly and Assembly Instructions16.1. Indoor Electronic Controllers, Cross Flow Fan and Indoor Fan MotorRemoval Procedures16.1.1. To remove

5816.1.3. To remove discharge grille

5916.1.4. To remove control board16.1.5. To remove cross flow fan and indoor fan motor

62.2. CS-CE9HKEW CU-CE9HKEITEM UNIT INDOOR UNIT OUTDOOR UNITPerformance Test Condition EUROVENTCOOLINGCapacitykW 2.60 (0.80 ~ 3.00)kCal/h 2240 (690 ~

60

6116.2. Outdoor Electronic Controller Removal Procedure Caution! When handling electronic controller, be careful of electrostatic discharge.1. Remove

6217 Technical Data17.1. Operation Characteristics17.1.1. CS-CE7HKEW CU-CE7HKE

63

64

65

6617.1.2. CS-CE9HKEW CU-CE9HKE

67

68

69

71. Cooling capacities are based on indoor temperature of 27qC D.B. (80.6qF D.B.), 19.0qC W.B. (66.2qF W.B.) and outdoor airtemperature of 35qC D.B. (

7017.1.3. CS-CE12HKEW CU-CE12HKE

71

72

73

7417.2. Sensible Capacity ChartO CS-CE7HKEW CU-CE7HKEO CS-CE9HKEW CU-CE9HKEO CS-CE12HKEW CU-CE12HKE230V Outdoor Temp. (qC)Indoor wet bulb temp.30 3

7518 Exploded View and Replacement Parts List18.1. Indoor UnitNoteThe above exploded view is for the purpose of parts disassembly and replacement.The

76(NOTE)• All parts are supplied from PHAAM, Malaysia (Vendor Code: 061).• “O” marked parts are recommended to be kept in stock.REF. NO.PART NAME &

7718.2. Outdoor UnitNoteThe above exploded view is for the purpose of parts disassembly and replacement.The non-numbered parts are not kept as standar

78(NOTE)• All parts are supplied from PHAAM, Malaysia (Vendor Code: 061).• “O” marked parts are recommended to be kept in stock.[PHAAM] Printed in Mal

82.3. CS-CE12HKEW CU-CE12HKEITEM UNIT INDOOR UNIT OUTDOOR UNITPerformance Test Condition EUROVENTCOOLINGCapacitykW 3.50 (0.80 ~ 4.00)kCal/h 3010 (690

91. Cooling capacities are based on indoor temperature of 27qC D.B. (80.6qF D.B.), 19.0qC W.B. (66.2qF W.B.) and outdoor airtemperature of 35qC D.B. (